Dear Kenwood Customer:

Thank you for your e-mail.  Quick Start Programming the TH-K2AT

1.	Push VFO button
2.	Press the ENT/# key now enter desired FREQUENCY via the keypad ( example 146.670 )
3.	Choose an OFFSET, the TH-K2AT has an Automatic Repeater Offset feature, you may also manually override that by
            pressing the MENU key, turn the main tuning knob to MENU # 6 SFT, now press MENU again now chose the correct 
            offset by turning the main tuning knob to the desired offset ( example OFF, +, or - ) when the correct one is chosen
            press the MENU key to store it. 
4.	Using PL/TONE/ENCODE for repeaters, press the MENU key turning the main tuning knob select MENU # 2 now press
            the MENU key the display will start to flash turn the main tuning knob to TONE, now press MENU key to store it.
5.         Selecting a PL/ENCODE/TONE press the MENU key turn the main tuning knob to MENU # 3 it will be flashing 
            now press MENU key again. You may now select your tone by turning the main tuning knob to the desired 
            TONE/PL/ENCODE ( example 127.3 ) to store it press the MENU key again. Now press the PTT to go back to the 
            normal frequency display.
6.         Storing all the information above into Memory, please press the F key followed by pressing the MR key the memory
            number will flash on the right side of the display. Now turn the main tuning knob to the desired memory channel 
            ( example # 5 ). Now store it by pressing the MR key again. 
7.          To recall that memory press the MR key. 
	


If you need further assistance, please e-mail us again.

Sincerely,
Kenwood Amateur Radio Customer Support